7.4 Removing a BusAdapter from the interface module
Tools required
Screwdriver 3.5 mm or TORX T10 (recommended): For loosening the fixing screws on the
BusAdapter.
Procedure
Step Procedure Illustration
1 Remove the bus cable from the BusAdapter if necessa‐
ry.
To do this, remove the bus con‐
nectors (RJ45 and FO) or the ca‐
ble (BA 2xFC).
2 Loosen the screws of the BusAdapter.
Use a screwdriver to do so.
3
Remove the BusAdapter.
Removal
7.4 Removing a BusAdapter from the interface module
ET 200SP HA Distributed I/O system
110 System Manual, 08/2019, A5E39261167-AD
To Next Page
Loading...
