Note
Failure of downstream stations is possible
Downstream stations on a bus segment can fail when the factory settings are restored on an
interface module.
Note
Substitute value reaction of the installed I/O modules on reset to factory settings
The I/O modules of the ET 200SP HA distributed I/O system are placed in a non-configured
state when they are reset to the factory settings.
Reference
You will find more information on the procedure in the STEP 7 online help.
Maintenance
8.8 Resetting the interface module to factory settings
ET 200SP HA Distributed I/O system
130 System Manual, 08/2019, A5E39261167-AD
To Next Page
Loading...
