9.6.4 Technical specifications - Terminal blocks
Use
You can find additional information on this in the section "Selecting a terminal block for I/O
modules (Page 32)".
Signal
voltage
Potential
group
Redun‐
dant
configu‐
ration
Potential dis‐
tributor
Process
terminals
Temperature
detection
Terminal
block type
Article number
Up to
24 V DC
Start again No No 32 Yes H1 light 6DL1193-6TP00-0DH1
Yes No 32 Yes M1 light 6DL1193-6TP00-0DM1
1)
No Yes, 32x L-
distributor
32+32 No P0 light 6DL1193-6TP00-0DP0
2)
No Yes, 32x M-
distributor
32+32 No N0 light 6DL1193-6TP00-0DN0
2)
Forwarding No No 32 Yes H1 dark 6DL1193-6TP00-0BH1
Yes No 32 Yes M1 dark 6DL1193-6TP00-0BM1
1)
No Yes, 32x L-
distributor
32+32 No P0 dark 6DL1193-6TP00-0BP0
2)
No Yes, 32x M-
distributor
32+32 No N0 dark 6DL1193-6TP00-0BN0
2)
24 V DC
with chan‐
nel isola‐
tion;
125 V DC
to
230 V DC
Start again No No 16 No K0 light 6DL1193-6TP00-0DK0
Forwarding No No 16 No K0 dark 6DL1193-6TP00-0BK0
1)
The terminal blocks (TB 45R...) are to be used exclusively for operating the I/O modules in IO redundancy or slot covers. The
process terminals run parallel to the contacts of the two I/O modules.
2)
Potential distributor for 32-channel I/O modules
Technical specifications
9.6 Technical specifications of subcomponents of the ET 200SP HA
ET 200SP HA Distributed I/O system
System Manual, 08/2019, A5E39261167-AD 153
To Next Page
Loading...
