Siemens SIMATIC ET 200SP HA - Explanation of the module;channel parameters

[[[[
0RGXOHF\FOHVN






① No smoothing (k = 1)
② Weak (k = 4)
③ Medium (k = 8)
④ Strong (k = 16)
5.4.7 Number of HART repetitions
De󹪝nition
Speci󹪝es the number of HART frame repetitions. If the I/O module receives no response or a
response with errors to a HART frame sent to the 󹪝eld device, the frame is repeated, i.e. sent to
the 󹪝eld device again.
5.4.8 Failure monitoring according to NE43
De󹪝nition
Enabling the failure monitoring changes the settings for monitoring the analog value.
Description
Failure monitoring according to NE43 can only be enabled for the measuring range 4...20 mA
HART.
• Disabled
The limits according to the S7 speci󹪝cations apply to the monitoring of the analog value
• Enabled
The limits for monitoring the analog value according to NE43
Parameters
5.4 Explanation of the module/channel parameters
AI 4xI 2-/4-wire HART ISOL HA
Equipment Manual, 07/2022, A5E50101523-AB 27