Siemens SIMATIC ET 200SP HA - Mt Led; Channel Status; Fault Leds

Description
The diagnostic display of the DIAG LED is as follows:
DIAG LED Meaning
O󹪜
The power supply of the ET 200SP HA is disrupted or switched o󹪜.
󹪞ashes
Module is not con󹪝gured.
On
Module parameters are assigned. No diagnostic message is pending.
󹪞ashes
Module parameters are assigned. At least one diagnostic message is pending.
6.2.2 MT LED
De󹪝nition
The MT LED provides maintenance information.
Description
The MT LED indicates the following maintenance status:
MT LED Meaning
O󹪜
No maintenance is required.
On
Maintenance is required. At least one maintenance event has occurred.
6.2.3 Channel status / fault LEDs
De󹪝nition
The channel status and channel fault LEDs provide you information about the status and faults
of the channels.
Displays and interrupts
6.2 LEDs
AI 4xI 2-/4-wire HART ISOL HA
Equipment Manual, 07/2022, A5E50101523-AB 33