Siemens SIMATIC ET 200SP HA - Application case 1: SIL3;Cat.3;PLd, 2-wire transmitter, 1 oo1

up of data records that are transferred internally between the IM and I/O module via the ET
200SP HA IO device. The data records must be created and interpreted by the client.
• HART signal (Page 41)
• HART con󹪝guration tool (Page 40)
• HART device status (Page 41)
Con󹪝guration
You con󹪝gure the individual channels with respect to the actual analog value output and the use
of the HART variables in the input address space of the module.
You can con󹪝gure one 󹪝eld device per channel. The con󹪝guration/parameter assignment of the
connected 󹪝eld device is then carried out from this con󹪝gured 󹪝eld device using PDM or the EDD
for the ET 200SP HA.
Parameter reassignment of the 󹪝eld devices
The I/O module generally accepts triggered recon󹪝gurations for 󹪝eld devices. Access rights can
only be allocated in the parameter assignment tool.
To reassign parameters of the 󹪝eld devices connected to the I/O module, proceed as follows:
1. You start the parameter reassignment of a 󹪝eld device using a HART command that you enter
using the SIMATIC PDM parameter assignment tool.
2. After you complete re-parameterization of a HART 󹪝eld device, the corresponding bit is set in
the HART device status of the connected 󹪝eld device (in the 2nd status byte).
3. The re-parameterization of the 󹪝eld device causes the analog module to issue a maintenance
message "Con󹪝guration changed", if this is enabled. This maintenance message should be
regarded as a notice and not an error. It is automatically deleted again by the I/O module after
approximately 1 minute.
Maintenance events (Page 65)
If enabled, a maintenance message can also be triggered by a new parameter assignment with
the handheld device.
7.2.2 HART con󹪝guration tool
De󹪝nition
The HART parameters can be set either using an external hand-held device (HART Handheld) or
a HART con󹪝guration tool (PDM). Both assume the function of a "client":
The parameter assignment tool a󹪜ects the entire I/O module; the HART handheld is connected
in parallel to the 󹪝eld device.
HART function
7.2 HART system connection
AI 4xI 2-/4-wire HART ISOL HA
40 Equipment Manual, 07/2022, A5E50101523-AB