Siemens SIMATIC ET 200SP HA - Application case 4: SIL3;Cat.4;PLe, 2- or 4-wire transmitter, 2 oo3

Article number 6DL1134-6UD00-0PK0
Diagnostics function Yes
Alarms
• Diagnostic alarm
Yes
• Limit value alarm
Yes; two upper and two lower limit values in each
case
Diagnoses
• Monitoring the supply voltage
Yes
• Wire-break
Yes; channel by channel
• Short-circuit
Yes; Channel-by-channel, short-circuit of the en‐
coder supply to ground or of an input to the encod‐
er supply
• Over󹪞ow/under󹪞ow
Yes; channel by channel
Diagnostics indication LED
• MAINT LED
Yes; Yellow LED
• Monitoring of the supply voltage (PWR-LED)
Yes; green PWR LED
• Channel status display
Yes; green LED
• for channel diagnostics
Yes; red LED
• for module diagnostics
Yes; green/red DIAG LED
Potential separation
Potential separation channels
• between the channels
Yes; 125 V AC / 150 V DC
• between the channels and backplane bus
Yes; 125 V AC / 150 V DC
• between the channels and the power supply
of the electronics
Yes; 125 V AC / 150 V DC
Permissible potential di󹪜erence
between di󹪜erent circuits 125 V AC / 150 V DC between the channels, 125 V
AC / 150 V DC between the channels and backplane
bus/supply voltage
Ambient conditions
Ambient temperature during operation
• horizontal installation, min.
-40 °C
• horizontal installation, max.
70 °C; Observe derating
• vertical installation, min.
-40 °C
• vertical installation, max.
70 °C; Observe derating
Dimensions
Width 22.5 mm
Height 115 mm
Depth 138 mm
Weights
Weight, approx. 163 g
Technical speci󹪝cations
8.1 Technical speci󹪝cations
AI 4xI 2-/4-wire HART ISOL HA
54 Equipment Manual, 07/2022, A5E50101523-AB