Siemens SIMATIC ET 200SP HA - Displays, alarms and messages

Channel parameters
Each channel parameter block contains the channel parameters for the analog output including
HART (14 bytes).
The following 󹪝gure shows the structure of the channel parameters for Channel 0 to 3.
x = 12 + (channel number * 14); with channel number 0…3
All unused bits and the bits or bytes marked as "reserved" must be set to zero.
You activate a channel parameter by setting the corresponding bit to "1" or the corresponding
value.
0HDVXUHPHQWW\SH
 $QDORJLQSXWGLVDEOHG
 &XUUHQWZLUHWUDQVGXFHU
 &XUUHQWZLUHWUDQVGXFHU
0HDVXULQJUDQJH
 P$
 P$
 P$+$57
 6WURQJ
 0HGLXP
 :HDN
 b1RQH
6PRRWKLQJ
,QWHUIHUHQFHIUHTXHQF\VXSSUHVVLRQ
 +]
 +]
 +]
(QDEOHGLDJQRVWLFV+$57
)DLOXUHPRQLWRULQJDFFRUGLQJWR1(
 (QDEOHG
 'LVDEOHG
:LUHEUHDNOLPLW
 P$
 P$ZLWKK\VWHUHVLV
+DUGZDUHLQWHUUXSWV
%LW ZKHQKLJKOLPLWLVYLRODWHG
%LW ZKHQORZOLPLWLVYLRODWHG
%LW ZKHQKLJKOLPLWLVYLRODWHG
%LW ZKHQORZOLPLWLVYLRODWHG
%\WH[
%\WH[
%\WH[
%\WH[





Parameters, diagnostics messages and address space
A.2 Parameter assignment and structure of the module/channel parameters
AI 4xI 2-/4-wire HART ISOL HA
Equipment Manual, 07/2022, A5E50101523-AB 61