Siemens SIMATIC ET 200SP HA - Diagnostics Alarms; Figure A-4 Header Information of Data Record 130

Header information
The 󹪝gure below shows the structure of the header information.
9HUVLRQ 
%\WH
%ORFNOHQJWK 
%\WH
%ORFNW\SH 
%\WH
5HVHUYHG 
%\WH




Figure A-4 Header information of data record 130
Parameters
The 󹪝gure below shows the parameter assignment of the 4 HART variables.
x = 4, 6, 8, 10
9DULDEOHLGHQWLILHU
&KDQQHOQXPEHU
%\WH[
%\WH[



 3ULPDU\
 6HFRQGDU\
 7HUWLDU\
 4XDWHUQDU\
 QRQ&L5
Figure A-5 Parameters of data record 130
The variable ID 15 = non/CiR prevents the I/O module from con󹪝guring/mappping a HART
variable; that is, the corresponding memory area in the input address area remains unallocated.
A.4 Diagnostics alarms
Diagnostics messages
A diagnostics message is generated for each detected diagnostics event. The DIAG LED on the
module 󹪞ashes.
Parameters, diagnostics messages and address space
A.4 Diagnostics alarms
AI 4xI 2-/4-wire HART ISOL HA
Equipment Manual, 07/2022, A5E50101523-AB 63