Human-machine Interface
8-2
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Operator control and monitoring of FM data/signals on the CPU 314
The data and signals that can be controlled and monitored at the control panel are
listed in the user data block. These data or signals must be processed by the user
program (for data and signals see Chapter 6 and Section 8.1).
What can I control on the FM 353?
Using the keyboard of the operator panel, you can change the data/signals in the
data blocks:
S Machine data DB No. 1210
S Increment sizes DB No. 1230
S Tool offset data DB No. 1220
S Traversing programs DB No. 1001...1199
What can I monitor on the FM 353?
The following data and signals can be displayed on the operator panel display:
S Machine data DB No. 1210
S Increment sizes DB No. 1230
S Tool offset data DB No. 1220
S Traversing programs DB No. 1001...1199
S Status messages DB No. 1000 (DB-SS) etc.
− Operating data, such as actual values
− Active NC blocks
− Linear measurements
− Actual value block change
− Checkback signals and error conditions
− Servicing data
The configuration package includes a pre-configured interface for the OP 07 and
OP 17 operator panels.
To Next Page
Loading...
