Siemens SIMATIC HMI Unified Comfort MTP700 - Page 126

Transferring data
6.5 Transferring a project with WinCC
Unified Comfort Panels
126 Operating Instructions, 03/2020, A5E46641217-AA
The "Load preview" dialog box contains alarms of type "Information" and "Warning".
Information The setting is compatible, the project can be loaded.
Warning
It is not possible to
change the setting in the
"Action" column.
The setting on the HMI device differs from the settings in the
configuration software. The project can still be loaded with this
setting.
Warning
The setting in the "Action"
column can be changed.
Note that the setting on the HMI device is different from the
setting in the configuration software. The project can be
loaded after the setting in the "Action" column has been
changed.
Error
It is not possible to
change the setting in the
"Action" column.
The project cannot be loaded. Adapt the setting in the
configuration or on the HMI device.
Error
The setting in the "Action"
column can be changed.
The project cannot be loaded. The project can be loaded after
the setting in the "Action" column has been changed.