Siemens SIMATIC HMI Unified Comfort MTP700 - Preface; Purpose of the operating instructions; Basic knowledge required; Scope of the operating instructions

Unified Comfort Panels
Operating Instructions, 03/2020, A5E46641217-AA
3
Preface
Purpose of the operating instructions
These operating instructions contain information based on the requirements for mechanical
engineering documentation. This information relates to the location, transport, storage,
mounting, use and maintenance.
These operating instructions are intended for:
● Users
● Commissioning engineers
● Maintenance personnel
Observe especially the information in the "Safety instructions" (Page 21) section.
You can find more information in the TIA Portal Information System.
Basic knowledge required
General knowledge of automation technology and process communication is needed to
understand the operating instructions. Knowledge of personal computers and Microsoft
operating systems is required.
Scope of the operating instructions
The operating instructions apply to the following HMI devices in conjunction with the
SIMATIC WinCC Unified software:
Name
Type
Article number, device with
Siemens logo
Article number, device with-
out Siemens logo
MTP700 Unified Comfort 7" device 6AV2128-3GB06-0AX0 6AV2128-3GB36-0AX0
MTP1000 Unified Comfort
10" device
6AV2128-3KB06-0AX0
6AV2128-3KB36-0AX0
MTP1200 Unified Comfort 12" device 6AV2128-3MB06-0AX0 6AV2128-3MB36-0AX0
MTP1500 Unified Comfort
15" device
6AV2128-3QB06-0AX0
6AV2128-3QB36-0AX0
MTP1900 Unified Comfort
19" device
6AV2128-3UB06-0AX0
6AV2128-3UB36-0AX0
MTP2200 Unified Comfort
22" device
6AV2128-3XB06-0AX0
6AV2128-3XB36-0AX0