Mounting/Extending
6.1 Installing the device
SIMATIC PN/J1939 LINK
34 Operating Instructions, 12/2018, A5E45307564-AA
Mounting to a control panel
Proceed as follows:
1. Drill holes (M4). The dimensions for the drill holes are available in the figure below.
2. Move the sliders
① to the outside until they latch in place.
3. Fasten the module with a cylinder head screw M4 as well as a spring lock washer and a
flat washer.
Note
Do not use a countersunk head screw.
The type of screw required depends on the type of material on whic
h the module is
mounted. Fasten the screw with the corresponding torque until the spring lock washer is
pressed flat.
Do not fasten the screws with excessive torque.
Figure 6-2 Control panel mounting of the PN/J1939 LINK
To Next Page
Loading...
