5-25
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
2. Press <F6> (ENTER) to confirm the selection.
Result: The SYSTEM START–UP/TEST: STATUS/CONTROL screen ap-
pears:
Digital modules are displayed in the “KM” format, analog modules in the
“KH” format. The following example shows the IP 262 module (address
identifier: 243 or 4AX) in the “KH” format:
Force
Outputs KH = 10FF E012 2340 1234
Status Identifier–related diagnostics
Inputs KH = 0123 4EAB 3333 FDAB
Status of outputs is retained
HELP EXIT
F2 F3 F4 F8F1
Station number: 4
Program file selected: B:TEST@@ET.200
SIMATIC S5 / COM ET 200
START–UP / TEST: STATUS/CONTROL
Station type: ET 200U–DP
Station name: PRESS
Station status:
ENTER HELP EXIT
F2 F3 F4 F8F1
Slot: 3 Identifier: 243
Figure 5-8 SYSTEM START–UP/TEST: STATUS/CONTROL Screen
COM ET 200 version 4.0 provides extended diagnostics messages in this
screen.
Up to 4 diagnostics messages are displayed in the “station status” field.
Another type of diagnostics is the identifier–related diagnostics (module dia-
gnostics). If the word “identifier–related diagnostics” is displayed, a module
has signalled a diagnostics status.
Diagnostics Mes-
sages in the
“...:STATUS/
FORCE” Screen
ET 200U(DP Standard): AddressAssignm.,Starting–Up, DiagnosingFaultsUsing COM ET 200
To Next Page
Loading...
