8-9
ET 200U Distributed I/O Station
EWA 4NEB 812 6087–02b
Power Supply Module PS 935 (6ES5 935–8ME11)
Periphery
Technical Specifications
Address identifier for ET 200U
DP Siemens
DP Standard
(2 slots)
4DI/4DI or 008/008
8DI/8DI or 016/016
Number of inputs
(only internal)
2 4 bits
Input voltage
rated value
permissible range
Polarity reversal protection
24 V DC
dyn. 18.5 to 30.2V DC
stat. 20.4 to 28.8 V DC
yes
Radio interference level A to VDE 0871
Input current at 24 V DC
rated value
inrush current limitation
efficiency
1.25 A
15 times rated current
approx. 75 %
Output voltage
rated value
permissible range
open–circuit voltage
9 V DC
8.55 to 9.45 V
yes
Output current
rated value
permissible range
overload recognition
2,5 A
0.0 to 2.5 A
2.5 to 2.7 A
Buffering during mains vol-
tage dips
duration of voltage dip
repeat rate
20 ms at 2.4 V / 2.5 A
1 s
Short–circuit protection
(output side)
yes, electronic switch–
off, non–retentive
Diagnostics yes
24 V DC input
voltage
9 V output voltage
short circuit/over-
load
Fault indication yes
Class of protection
Galvanic isolation
class 1
no
Conductor cross–section
flexible (with core end
sleeve)
solid
2 0.5 to 1.5 mm
2
2 0.5 to 1.5 mm
2
Power consumption approx. 30 W
Dimensions in mm
(W H D)
45.4 135 120
Power loss of the module
Weight
10 W
500 g (1.1 lbs)
Module Spectrum
To Next Page
Loading...
