Siemens SIMATIC S5 ET 200U - Page 375

Index-4
ET 200 Distributed I/O Station
EWA 4NEB 812 6087–02b
Digital input module, 8-16
4x24 V DC, 8-16
8x115 V AC, 8-23
8x230 V AC, 8-24
8x24 V DC, 8-17, 8-22
8x5 to 24 V DC, 8-25
Digital input modules
4x115 V AC, 8-20
4x230 V AC, 8-21
4x24 V to 60 V DC, 8-19
Digital input/output modules, 8-39
crimp snap–in connector, 40–pin, 8-39
crimp snap–in connector; 40–pin, 8-18
screw plug connector, 40–pin, 8-39
screw plug connector; 40–pin, 8-18
Digital modules, connecting, 3-16
Digital output module
4x 24 V DC / 2 A, 8-28
4x115 to 230 V AC / 1 A, 8-31
4x24 to 60 V DC / 0.5 A, 8-30
4x24 V DC / 0.5 A, 8-26
8x115 to 230 V AC / 0.5 A, 8-33
8x24 V DC / 1 A, 8-32
8x5 to 24 V DC / 0.1 A, 8-34
digital output module 4x24 V DC / 0.5 A,
8-29
relay output module 4x30 V DC / 230 V AC,
8-37
relay output module 8x30 V DC / 230 V AC,
8-35
DIN 19245 E, Part 3, 1-2
DIN 19245, Part 1, 1-2, 1-4, B-2
DIN 19245, Part 2, 1-5
DIN 19245, Part 3, 1-4
DIN E 19245, Part 3, B-2
Dismantling, 3-2, 3-7
IM 318–B, 3-7
power supply, 3-7
Distributed I/O, B-2
Distributed I/O station, B-2
DP inputs, “DP inputs” object, 6-27
DP master address, ET 200U(DP Standard/
FMS), 6-21
DP outputs, “DP outputs” object, 6-28
DP Siemens, 1-3–1-8, 4-2, B-2
DP slave parameterization frame, ET 200U
(DP Standard), 5-15–5-16
DP Standard, 1-3–1-8, 5-2, B-2
E
Earth, B-2
Earthing, B-2
Earthing electrode, B-2
Electrical configuration, 3-23
Electronic cam controller module IP 264,
technical specifications, 9-52
ET 200, 1-2, B-3
ET 200 in a mixed configuration, Requirements
for operating an IM 318–C, 6-5
ET 200(DP Standard), with an IM 318–C, 6-2
ET 200(DP Standard/FMS), structure of diagno-
stics data, 6-19
ET 200U, 1-3
addressing range, 3-1
ET 200U (DP Siemens), address assignment
using COM ET 200, 4-3–4-16
ET 200U (DP Standard), address assignment
using COM ET 200, 5-3–5-19
Index