Configuring and Parameter Assignment the CP 341
5.4 Assigning Parameters to the Communications Protocols
CP 341 Point-to-Point Communication, Installation and Parameter Assignment
118 Manual, 09/2008, A5E02191071-01
5.4 Assigning Parameters to the Communications Protocols
You must parameterize the CP 341 and its serial interface after having entered the CP 341
in the configuration table. In the case of the printer driver, you can also configure message
texts for printer output.
Parameter assignment
The term "parameter assignment" is used in the following to describe the setting of protocol-
specific parameters. The parameter assignment is carried out with the CP 341: Point-to-
Point Communication, Parameter Assignment parameter assignment interface.
You start the parameter assignment interface by double-clicking the order number (CP 341)
in the configuration table or by selecting the CP 341 and then the Edit > Object Properties
menu command. The "Properties – CP 341" dialog will appear.
Click the "Parameters" button to go to protocol selection. Set the protocol and double-click
the icon for the transmission protocol (an envelope). This takes you to the dialog for setting
the protocol-specific parameters.
Further information?
The basic operation of the CP 341: Point-to-Point Communication, Parameter Assignment
parameter assignment interface is the same for all communication processors and is self-
explanatory. For this reason, the parameter assignment interface is not described in detail
here.
Also, the online help will support you when working with the parameter assignment interface.
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/
To Next Page
Loading...
