Installing and removing FM 350-1
2.3 Removing FM 350-1
FM 350-1 Counter module
Manual, 05/2011, A5E03648639-01
23
2.3 Removing FM 350-1
Rules
No special protection measures (ESD guidelines) are required for removing the FM 350-1.
Required Tools
You require a flat-bladed screwdriver 4.5 mm to remove the FM 350-1.
Procedure for Removal/Replacement of Modules
How to remove the FM 350-1:
1. Switch off the auxiliary voltage and the load voltage at the front connector.
2. Switch the CPU to STOP. Switch off the power supply.
3. Open the front door. If necessary, remove the labeling strips.
4. Release the front connector and pull it out.
5. Loosen the fixing screw on the module.
6. Swing the module out of the mounting rail and unhook it.
7. Install the new module if applicable.
Further Notes
Manual /1/ contains further notes on installing and removing modules.
To Next Page
Loading...
