Siemens SIMATIC S7-300 Module data Product Information

Commissioning
3.4 Configuring the drive components
Connection of the SINAMICS S120 to the Technology CPU
Product Information, 09/2011, A5E00480378-04
39
3.4.3 Manual configuring
Introduction
The manual configuring can only be performed in offline mode of S7T Config.
The components of the drive system that are present must be configured manually using
S7T Config.
Various infeed modules of the SINAMICS
The procedure to be adopted for the manual configuring depends on the SINAMICS infeed.
Three different types of SINAMICS infeeds are available:
● Active Line Modules (ALM)
● Basic Line Modules (BLM)
● Smart Line Modules (SLM)
The same dialogs are used for configuring of Active Line Module and the Basic Line Module;
the configuring of the Smart Line Module differs in some configuration steps.
Note
The configuring with an Active Line Module (ALM) and the configuring of the
Smart Line Module (SLM) is described separately in the following sections.
Each configuring guide contains all required steps. Therefore, select the appropriate
section for your configuration.

Siemens SIMATIC S7-300 Module data Specifications

General

Series	S7-300
Manufacturer	Siemens
Protection Class	IP20
System	SIMATIC S7-300
Digital Inputs	Varies by module
Digital Outputs	Varies by module
Analog Inputs	Varies by module
Analog Outputs	Varies by module
Central Processing Unit	Varies by CPU model
Supply Voltage	24V DC or 120/230V AC
CPU Type	Varies (e.g., CPU 312, CPU 315, etc.)
Memory	Varies by CPU model
Communication Interfaces	MPI, PROFIBUS
Programming Languages	LAD, FBD, STL, SCL, GRAPH
Operating Temperature	0°C to 60°C
Storage Temperature	-40°C to 70°C
Relative Humidity	10% to 95% (non-condensing)