03/2013 4 Organizational tasks
4.1 Maintenance
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
4-219
4.1.3 Executing/closing a maintenance job (control)
Function description
Maintenance personnel can view and open jobs in the SINUMERIK Integrate menu
(maintenance services maintenance jobs) on the control.
To limit the length of execution for maintenance procedures, there is the option of
protecting the maintenance job from entries and changes when it is opened. Third
parties will see that the maintenance procedure is already taking place and will be
acknowledged with the appropriate status. See also Section: Test series on the
machine
Function Description
Execute maintenance job The maintenance personnel can edit maintenance
jobs that are due:
• Open (block for third-party access)
• Add and change comments
• Acknowledge as correctly executed
• Acknowledge as incorrectly executed, if this is not
possible. It may be advisable to add a comment in
such cases.
Condition monitor:
Perform axis test of
maintenance job
The maintenance personnel can perform the axis
tests that are linked to the maintenance job via the
maintenance schedule.
View maintenance job The maintenance personnel can display the
information stored in the maintenance schedule (from
which the maintenance job was generated), such as
work instructions and attached files (drawings,
extracts from the machine documentation, etc.).
These documents must have been stored as PDF
documents during the planning in the maintenance
schedule or in the job.
The same maintenance job information is shown on both the user interface of the
control and the PC.
However, to facilitate handling, only the maintenance jobs of a machine are
displayed that are soon due, are due and open.
To this effect, menu operation is limited: The jobs cannot be edited; but only
opened and acknowledged, and comments can be added.
To Next Page
Loading...
Need help?
General
