2 Machine information 03/2013
2.2 Variable monitors – time Series – measurements and measurement series
© Siemens AG 2006-2013 All Rights Reserved
2-52 SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
2.2.7 Variable monitors
Function description
Variable monitors enable the recording in the control of changes over time of any
status data. The variable monitors are essentially for long-term recording in slow
data recording cycles (as opposed to the PLC trace).
Variables can be recorded in a variable monitor. Depending on the variable type,
the recording cycle is not absolutely synchronous. The PLC variables recorded can
be from the PLC environment: inputs, outputs, counters, flags, and any data
addresses in PLC blocks. From the NC environment, they can be machine data,
setting data, system variables and others.
The variables recorded can be scaled and assigned freely definable units.
Individual variables of a variable monitor can be identified as counting variables
(e.g. workpiece counters). These variables can be used in the configuration of
interval triggers to trigger recurring actions after a certain number of counting units
have elapsed. Counting variables are counted up monotonically. Resetting of the
variables in the control is compensated for by the system because the count is
resumed on the basis of the last value before reset.
Limit values can be configured for each variable for automatic monitoring of the
state. Actions can be triggered when limit values are violated. This is the same as
described for the control monitors.
To Next Page
Loading...
Need help?
General
