Name: Siemens SIMATIC S7-300 Module data
Brand: Siemens
Rating: 4 (1 reviews)

To Next Page

To Previous Page

03/2013 2 Machine information

2.3 Test series on the machine

SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013

2-61

2.3.3 Prolog and epilog program for a measurement

Function description

To prepare the control making it suitable for the test, an NC program that has been

specially adapted to the machine by the machine manufacturer or end user is

executed at the beginning of the test. This means that machine settings can be

specifically changed so that the test can be performed (example: Disabling

transformations and couplings, resetting pre-set G codes).

Suitable programming of the prolog and epilog program can influence how the test

is performed. When a test series is carried out, individual measurement series can

only be hidden under the tested conditions (e.g. due to a risk of collision).

The prolog and epilog program is reloaded into the control with name

"N_EPS_PROLOGEPILOG_SPF" every time a test is run. The NC program editor

of the operator panel can be used to modify this program.

After the test has been performed, SINUMERIK Integrate automatically checks

whether the prolog/epilog program was changed. If required by the machine

operator, it saves the program permanently.

Fig. 2-39: Prompt for NC-START

Other manuals for Siemens SIMATIC S7-300 Module data

Questions and Answers:

Need help?

Do you have a question about the Siemens SIMATIC S7-300 Module data and is the answer not in the manual?

General