84
2.13 Mounting and Operation
WARNING!
During operation of electric devices, certain parts of the
device are subject to dangerous voltages. Ignoring the
warning notes can result in severe injury or damage to
property. Strict compliance with all safety information is
imperative.
The SIMEAS
P is a build-in device and must therefore be
installed on a switchboard or in a control cabinet. After
installation, it is important that all terminals are properly
covered to prevent accidental contact with energized parts.
• The device location should be largely free from
vibrations. The device must be operated within
allowable ambient temperature limits (see technical
specifications).
• Operating the device outside of the operating
temperature range can lead to measurement errors and
device failure.
• Screw-type terminals for 2.5 mm
2
or 4 mm
2
• Steps must be taken to prevent condensation on or
within the device during operation.
• Steps should be taken to minimize exposure of the
device to direct sun light and large temperature
variations.
To Next Page
Loading...
