80
2.18.4 Notes
• The selection of the measured quantity depends on the se-
lected input voltage and current connections.
• If the number selected is too large, #ERR# is displayed and the
input value is automatically set to the maximum value.
• If the power supply voltage is switched off during program-
ming, the message illustrated below appears when the device
is restarted. Therefore, the power supply voltage should only
be switched off in level 1 (measuring screens).
Note:
This means, that you should always leave the parameter screens
completely (OK or Cancel) until the measurement screens are
displayed again. This ensures that all parameters will be accepted
by the device.
Note:
Please check the parameters and the adjustment data afterwards,
to ensure the correct function of the SIMEAS P.
If you have adjusted the device manually, these data will not be
overwritten by default settings.
Message
Select "No" via the
buttons to retain the settings as they
existed prior to the loss of power supply voltage.
Choose "Yes" by pressing the ENTER button to restore the default
settings.
Attention!
Parameter incorrect
reset?
No Yes
(arrow) (Enter)
To Next Page
Loading...
