EasyManua.ls Logo

Siemens SIMEAS P 7KG7750 - Transmitted Telegrams Vs. Network Type and I;O Module Assembly

Siemens SIMEAS P 7KG7750
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Data Mapping
34
Power Meter, SIMEAS P 7KG7750/55, Manual
E50417-B1076-C375-A3, Release 01.2009
3.1.2.9 Transmitted Telegrams vs. Network Type and I/O Module Assembly
Depending on the selected Network type (ref. to Figure 3-1), the parameters to the
transmisson of the harmonics (see chapter 2.1.2) and the assembled I/O modules
either all or only a selected number of the above descriped telegrams are sent to the
IEC 60870-5-103 master on request of class 2 data.
For an association of the measured quantities to the selected Network type please
refer to Table 3-1 in the SIMEAS P50 Device Manual (refer to page 3 for the order
number of this document).
Table 3-3 Transmitted telegrams vs. Network type and I/O module assembly
The telegrams are transferred sequentially, i.e. every time the IEC 60870-5-103 mas-
ter requests class 2 data, the IEC 60870-5-103 slave sends the next following tele-
gram in the order shown in Table 3-3.
When the last additional measurands telegram was sent, it starts with "Compatible
Measurands II" again.
The IEC 60870-5-103 master can request
only one telegram or
a part of the telegrams or
all telegrams
supported according to the Network type from one device and then change to the
next device.
Network Type
Single-phase
network
Three-wire
tree-phase
balanced
Three-wire
three-phase
unbalanced 3I
Three-wire
three-phase
unbalanced 2I
Four-wire
three-phase
balanced
Four-wire
three-phase
unbalanced
Compatible
Measurands II
X
1
XXXXX
Private Measurands
1-phase additional
X- - - - X
Private Measurands
3-phase, first additional
-XX XXX
Private Measurands
3-phase, second additional
-- - - -X
Private Measurands
1-phase additional (with
harmonics if parameter)
XX X X X X
Private Measurands
3-phase, first additional
(with harmonics if parame-
ter)
--XX-X
Private Measurands
Analog Inputs
XX X X X X
Private Measurands
Analog Outputs
XX X X X X
1 The values for 3N as well as for phases L
2
and L
3
in the Compatible Measurands telegram which are not avail-
able for this Network type are indicated as invalid.

Other manuals for Siemens SIMEAS P 7KG7750

Related product manuals