04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–97
SINUMERIK 840C / SIMODRIVE 611–D (DA)
100413 V.24: timeout triggered
Serial communication via V.24
Data not read in or out
No data were read in or retrieved during the parametrized period of time (file par_v24.ini)
Check the communication parameters.
Alarm from SW 6.3
100414 V.24: Port cannot be closed (incorrect ID)
Serial communication via V.24
Possible communication difficulties
Internal error on terminating communication
Check OEM application for faulty communication with serial interface
Alarm from SW 6.3
100503 File <%1> not loaded
When loading servo and drive data
The file is not transferred
The disk does not contain the file to be loaded from among the initial program loader files in directory
c:\mmc.001\siem.069\servo.111 or c:\mmc.001\user.005\servo.111.
Copy file <%1> to the hard disk
Alarm from SW 6.3
100803 No connection to operator panel
On power up of control
Operator panel does not respond
An error occurred while the control was powering up and communication was being established between the oper-
ator panel and MMC.
Check whether:
S the link between the operator panel and MMC is in good condition
S V.24 is functioning
S latest version of operator panel firmware is available
Alarm from SW 6.3
101000 NCK system being loaded
When NCK system is being loaded
None
Message appears in the red bar when the system is being loaded
–
101001 PLC system being loaded
When PLC system is being loaded
None
Message appears in the red bar when the system is being loaded
–
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
01/99
To Next Page
Loading...
