Siemens SIMOREG DC Master 6RA7018-6DS22 - Installation; Connections

02.00 Contents
Siemens AG 6RX1700-0AD76 0-3
SIMOREG DC Master Operating Instrctions
Page
6 Connections
6.1 Installation instructions for proper EMC installation of drives 6-2
6.1.1 Fundamental principles of EMC 6-2
6.1.1.1 What is EMC 6-2
6.1.1.2 Noise radiation and noise immunity 6-2
6.1.1.3 Limit values 6-2
6.1.1.4 SIMOREG converters in industrial applications 6-3
6.1.1.5 Non-grounded supply systems 6-3
6.1.1.6 EMC planning 6-3
6.1.2 Proper EMC installation of drives (installation instructions) 6-4
6.1.2.1 General 6-4
6.1.2.2 Rules for proper EMC installation 6-4
6.1.2.3 Converter component arrangement 6-13
6.1.2.4 List of the recommended radio interference suppression filters 6-14
6.1.3 Information on line-side harmonics generated by converters in a
fully-controlled three-phase bridge circuit configuration 6-15
6.2 Block diagrams with recommended connection 6-17
6.3 Parallel connection of converters 6-18
6.3.1 Circuit diagram showing parallel connection of SIMOREG converters 6-18
6.3.2 Parameterization of SIMOREG converters for parallel connection 6-19
6.3.2.1 Standard operating mode 6-19
6.3.2.2 Operating mode "N+1 mode" (redundancy mode) 6-20
6.4 Power connections 6-22
6.4.1 Converters: 30A, 1Q 6-22
6.4.2 Converters: 60A, 1Q 6-23
6.4.3 Converters: 90A to 280A, 1Q 6-24
6.4.4 Converters: 400A to 600A, 1Q 6-25
6.4.5 Converters: 720A, 1Q 6-26
6.4.6 Converters: 800 to 850A, 1Q 6-27
6.4.7 Converters: 900A to 950A, 1Q 6-28
6.4.8 Converters: 1000 to 1200A, 1Q 6-29
6.4.9 Converters: 1500 to 2000A, 1Q 6-30
6.4.10 Converters: 15 to 30A, 4Q 6-32
6.4.11 Converters: 60A, 4Q 6-33
6.4.12 Converters: 90A to 210A, 4Q 6-34
6.4.13 Converters: 280A, 4Q 6-35
6.4.14 Converters: 400A, 4Q 6-36
6.4.15 Converters: 450A to 600A, 4Q 6-37
6.4.16 Converters: 760A, 4Q 6-38
6.4.17 Converters: 850A, 4Q 6-39