Siemens SIMOTICS L-1FN3 - Technical Data and Characteristics

1FN3 linear motors
Configuration Manual, 10/2018, 6SN1197-0AB86-0BP2
165
Technical data and characteristics
6
The technical data and characteristics for the 1FN3 linear motors are stated in this chapter.
This data collection provides the motor data required for configuration and contains a
number of additional data for more detailed calculations for detailed analyses and problem
analyses.
Parameters that are used in the drive system for the control of a drive can differ from the
data specified here.
Technical data subject to change.
Note
System
-specific data refer to the combination of 1FN3 linear motors with SINAMICS S120
drive systems.
Unless otherwise stated, the following constraints apply here:
•
The DC link voltage U
DC
is 600 V, the converter output voltage U
a max
is 425 V
•
The motor is water-cooled with the recommended minimum volume flow rate V
P,H,MIN
according to the data sheet and a water flow temperature T
VORL
of 35 °C
•
The rated temperature of the motor winding T
N
is 120 °C
•
Voltages and currents are specified as rms values.
•
Installation altitude of the motors up to 2000 m above sea level.