Siemens SINAMICS G120 CU240B-2 - Page 231

Functions
7.11 Switchover between different settings
Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 07/2010, FW 4.3.2, A5E02299792B AA
231
,QYHUWHUFRQWURO
&RPPDQGVRXUFHV
6HWSRLQWSURFHVVLQJ
3URWHFWLRQ
IXQFWLRQV
6WDWXV
PHVVDJHV
6DIHW\
IXQFWLRQV
&RP
PDQG
VRXUFHV
IDLOVDIH
0RWRU
FRQWURO
6HWSRLQW
VRXUFHV
7HF KQRORJLFDO
IXQFWLRQV
 'LJLWDOLQSXWV
 2SHUDWRU3DQHO
 )LHOGEXV
 $QDORJ
 LQSXWV
 )L[HG
VHWSRLQWV
 0RWRUL]HG
SRWHQWLRPHWHU
 -RJPRGH
)LHOGEXV
 )LHOGEXV
 'LJLWDORXWSXWV
Figure 7-30 CDS switchover in the inverter
Use parameter P0170 to define the number of command data sets (2, 3 or 4).
Table 7- 42 Selecting the number of command data sets
Parameter Description
P0010 = 15 Drive commissioning: Data sets
P0170 Number of command data sets (factory setting: 2)
P0170 = 2, 3 or 4
P0010 = 0 Drive commissioning: Ready
The command data sets are switched over using parameters P0810 and P0811. Parameters
P0810 and P0811 are interlinked to control commands, e.g. the digital inputs of the inverter,
using BICO technology.