Siemens Sinamics G120 CU240S DP - Page 143

Functions
5.10 Technological functions
Frequency inverter
Operating Instructions, 08.10. 2008, t.b.d.
143
Table 5- 44 Technology controller parameters
Parameter Description
P2200 =
…
Enable technology controller
P2251 =
…
Control mode (correction or specification of speed setpoint)
P2253 =
…
Setpoint selection
P2254 =
…
Supplementary setpoint
P2255 =
…
Setpoint scaling
P2256 =
…
Supplementary setpoint scaling
P2257 =
…
Ramp-up time for setpoint
P2258 =
…
Ramp-down time for setpoint
P2263 =
…
Technology controller with or without differential component
P2264 =
…
Selection of source for the actual value
P2265 =
…
Time constant for the setpoint filter
P2267 =
…
Maximum value for feedback
P2268 =
…
Minimum value for feedback
P2269 =
…
Scaling for feedback
P2270 =
…
Function selection for feedback
P2271 =
…
Inversion of controller feedback
P2274 =
…
Derivative time
P2280 =
…
Proportional gain
P2285 =
…
Integral time
P2291 =
…
Maximum value for the output
P2292 =
…
Minimum value for the output
P2293 =
…
Ramp-up/ramp-down time for limit
P2295 =
…
Output scaling