Functions
5.11 Operation in fieldbus systems
Frequency inverter
164 Operating Instructions, 08.10. 2008, t.b.d.
Integrating the frequency converter in a higher-level SIMATIC controller
Once you have set the PROFIBUS address of the frequency converter, all the remaining
settings required for integrating it in the SIMATIC controller are carried out in STEP 7 with
HW Config.
Creating a STEP 7 project
Create a new STEP 7 project and assign a project name (e.g. "G120_in_S7").
Figure 5-20 Create a new project in STEP 7
Configuring SIMATIC 300 and creating the PROFIBUS network
Add an S7 300 CPU.
Figure 5-21 Add a SIMATIC 300 station
To Next Page
Loading...
