Siemens Sinamics G120 CU240S DP - Interfaces, Connectors, Switches, Control Terminals, Leds on the CU

Connection
3.4 Installing the Control Unit
Frequency inverter
Operating Instructions, 08.10. 2008, t.b.d.
41
3.4.1 Interfaces, connectors, switches, control terminals, LEDs on the CU
Overview of the process and user interfaces
The following interfaces are provided on the Control Unit
● Terminals for the input and output signals
● Card slot to upload and download frequency inverter settings
● Connector to communicate with higher-level controls
● DIP switches to configure the speed encoder, the analog inputs and, if required, to set the
PROFIBUS address.
● LEDs for diagnostics
It also shows where they are located.
&86
&8(
00&FDUGVORW
',3VZLWFKIRUFRQILJXULQJWKHDQDORJ
LQSXWVDQGHQFRGHU
',3VZLWFKIRUVHWWLQJWKH352),%86DGGUHVVRQWKH
VLGHRIWKH&8DYDLODEOHZLWK'3YDULDQWVRQO\
/('IRULQGLFDWLQJWKHVWDWXVRIWKHLQYHUWHU
,QWHUIDFHIRU%233&FRQQHFWLRQNLW
7HUPLQDOVIRUGLJLWDODQDORJLQSXWRXWSXW
VLJQDOV
&RPPXQLFDWLRQVLQWHUIDFHIRUDKLJKHUOHYHOFRQWUROOHU
DV68%'RU5-FRQQHFWRU
',3VZLWFKIRUEXVWHUPLQDWLQJUHVLVWRU
6KLHOGSODWH