Siemens Sinamics G120 CU240S DP - Commissioning Procedures

Frequency inverter
Operating Instructions, 08.10. 2008, t.b.d.
45
Commissioning
4
Alternative commissioning options
The functions of a frequency inverter are activated and configured using parameters.
Parameters can either be accessed from the operator control/display instrument (Operator
Panel) or using the STARTER software from the PC via the appropriate frequency inverter
interface.
Inverters can also be parameterized by saving the valid inverter parameter set on an MMC
memory card or on the Operator Panel and then transferring it to a different frequency
inverter with the same configuration and function.
The commissioning scenarios listed below are described in the following sections:
● Commissioning, using the factory settings
● Commissioning with the STARTER software
● Commissioning using the Operator Panel
● Data backup with the Operator Panel and MMC memory card
Users can access the inverter parameters via the following interfaces
2SWLRQSRUW
866RQ56
%23
PRXQWHG
GLUHFWO\
67$57(5YLD
3&FRQQHFWLRQ
NLW
00&67$57(5YLD
68%'FDEOH
56!56FRQYHUWHU
3&LQYHUWHU
FRQQHFWLRQNLW
866352),%86352),1(7
67$57(5YLD
EXV