Siemens Sinamics G120 Series - 1.4.2 Connector Input Parameters

Parameters
Connector/Binector (BICO)-Parameters
1-308
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
1.4.2 Connector Input Parameters
p0095[0...9] CI: Display PZD signals / PZD signals
p0771[0...1] CI: AO / AO
p1042[0...2] CI: MOP auto setpoint / MOP auto setpoint
p1044[0...2] CI: MOP rampgenerator setpoint / MOP RFG setpoint
p1070[0...2] CI: Main setpoint / Main setpoint
p1071[0...2] CI: Main setpoint scaling / Main setp scal
p1075[0...2] CI: Additional setpoint / Add. setpoint
p1076[0...2] CI: Additional setpoint scaling / Add. setp.scal
p1330[0...2] CI: Voltage setpoint / Voltage setp.
p1478[0...2] CI: Set integrator value n-ctrl. / Set int. value
p1503[0...2] CI: Torque setpoint / Torque setp.
p1511[0...2] CI: Additional torque setpoint / Add. trq. setp
p1522[0...2] CI: Upper torque limit / Upper trq. lim
p1523[0...2] CI: Lower torque limit / Lower trq. lim
p2016[0...7] CI: PZD to USS on RS232 / PZD->USS
p2019[0...7] CI: PZD to USS on RS485 (USS) / PZD->COM (USS)
p2051[0...7] CI: PZD to Fieldbus / PZD to FB
p2151[0...2] CI: Speed setpoint for messages / n-Set for msg
p2242[0...2] CI: PID-MOP auto setpoint / PMOP auto setpoint
p2244[0...2] CI: PID-MOP rampgenerator setpoint / PMOP RFG setpoint
p2253[0...2] CI: PID setpoint / PID setpoint
p2254[0...2] CI: PID trim source / CI:PID trim source
p2264[0...2] CI: PID feedback / PID feedback
p2869[0...1] CI: ADD 1 / ADD 1
p2871[0...1] CI: ADD 2 / ADD 2
p2873[0...1] CI: SUB 1 / SUB 1
p2875[0...1] CI: SUB 2 / SUB 2
p2877[0...1] CI: MUL 1 / MUL 1
p2879[0...1] CI: MUL 2 / MUL 2
p2881[0...1] CI: DIV 1 / DIV 1
p2883[0...1] CI: DIV 2 / DIV 2
p2885[0...1] CI: CMP 1 / CMP 1
p2887[0...1] CI: CMP 2 / CMP 2
p8851[0...7] CI: PZD to Fieldbus / PZD to FB