Siemens SINAMICS G120 - Page 179

Configuring the fieldbus
7.6 Communication via RS485
Inverter with CU230P-2 Control Units
Operating Instructions, 11/2013, FW V4.6.6, A5E02430659B AG
179
Instance
ID
Object name
Description
Unit
Range
Access
type
Parameter
AI10 ANALOG INPUT 0
SCALED
Scaled AI 0 input signal % inverter-dependent R r0755[0]
AI11 ANALOG INPUT 1
SCALED
Scaled AI 1 input signal % inverter-dependent R r0755[1]
AI12 ANALOG INPUT 2
SCALED
Scaled AI 2 input signal % inverter-dependent R r0755[2]
AI13 ANALOG INPUT 3
SCALED
Scaled AI 3 input signal % inverter-dependent R r0755[3]
Analog Output Objects
Instance
ID
Object name
Description
Unit
Range
Access
type
Parameter
AO0
ANALOG OUTPUT 0
AI0 value
%
inverter-dependent
C
p0791.0
AO1
ANALOG OUTPUT 1
AI1 value
%
inverter-dependent
C
p0791.1
Analog Value Objects
Instance
ID
Object name
Description
Unit
Range
Access
type
Parameter
AV0
OUTPUT FREQ_Hz
Output frequency (Hz)
Hz
inverter-dependent
R
r0024
AV1
OUTPUT FREQ_PCT
Output frequency (%)
%
inverter-dependent
R
HIW
AV2
OUTPUT SPEED
Motor speed
RPM
inverter-dependent
R
r0022
AV3
DC BUS VOLT
DC-link voltage.
V
inverter-dependent
R
r0026
AV4
OUTPUT VOLT
Output voltage
V
inverter-dependent
R
r0025
AV5
CURRENT
Motor current
A
inverter-dependent
R
r0027
AV6 TORQUE Motor torque Nm inverter-dependent R r0031
AV7
POWER
Motor power
kW
inverter-dependent
R
r0032
AV8 DRIVE TEMP Heat sink temperature °C inverter-dependent R r0037
AV9 MOTOR TEMP Measured or calculated motor
temperature
°C inverter-dependent R r0035
AV10 KWH (NR) Cumulative inverter energy
consumption (cannot be reset!)
kWh inverter-dependent R r0039
AV12 INV RUN TIME (R) Motor's operating hours (is reset
by entering "0")
h 0 … 4294967295 W p0650
AV13
INV Model
Code number of Power Module
---
inverter-dependent
R
r0200
AV14
INV FW VER
Firmware version
---
inverter-dependent
R
r0018
AV15
INV POWER
Rated power of the inverter
kW
inverter-dependent
R
r0206
AV16
RPM STPT 1
Reference speed of the inverter
RPM
6.0 … 210000
W
p2000
AV17 FREQ STPT PCT Setpoint 1 (when controlling via
BACnet)
% -199.99 … 199.99 C HSW
AV18 ACT FAULT Number of the fault due to be
dealt with
--- inverter-dependent R r0947[0]