Siemens SINAMICS G120 - p20317 NCM 0 run sequence; NCM 0 RunSeq; p20318[0...1] CI: NCM 1 inputs; NCM 1 inputs; r20319 BO: NCM 1 output QU; NCM 1 output QU; r20320 BO: NCM 1 output QE; NCM 1 output QE

To Next Page

To Previous Page

SINAMICS G120 Control Units CU240B-2/CU240E-2

List Manual (LH11), 01/2016, A5E33839529

515

2 Parameters

2.2 List of parameters

Description: Setting parameter for the run sequence of instance NCM 0 within the run-time group set in p20316.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source of input quantities X0 and X1 of instance NCM 1 of the numeric comparator.

Index: [0] = Input X0

[1] = Input X1

Description: Display parameter for binary quantity QU of instance NCM 1 of the numeric comparator.

QU is only set if X0 > X1.

Description: Display parameter for binary quantity QE of instance NCM 1 of the numeric comparator.

QE is only set if X0 = X1.

Description: Display parameter for binary quantity QL of instance NCM 1 of the numeric comparator.

QL is only set if X0 < X1.

p20317 NCM 0 run sequence / NCM 0 RunSeq

Access level: 3 Calculated: - Data type: Unsigned16

Can be changed: T Scaling: - Dyn. index: -