Siemens SINAMICS G120 - Page 64

De󹪝ning the analog signals for controlling referencing
Procedure


1. De󹪝ne the signal source for the velocity override.
Direct setpoint input (MDI) (Page 88)
2. Change the source for the reference point coordinate, if necessary.
You have now de󹪝ned the analog signals for controlling.
❒
Parameter Meaning
p2595 Start referencing
p2598 Reference point coordinate, signal source
p2599 Reference point coordinate value
p2600 Reference point approach, reference point o󹪜set
p2604 Reference point approach, start direction
p2605 Reference point approach, approach velocity, reference cam
p2606 Reference point approach reference cam, maximum distance
p2607 Reference point approach reference cam available
p2608 Reference point approach, approach velocity, zero mark
p2609 Reference point approach, max distance reference cam and zero mark
p2610 Reference point approach, tolerance band for the distance to the zero mark
p2611 Reference point approach, approach velocity, reference point
p2612 Reference point approach, reference cam
p2613 Reference point approach reversing cam, minus
p2614 Reference point approach reversing cam, plus
r2684.0 Reference point approach active
r2684.11 Reference point set
Commissioning
6.6 Referencing
Basic positioner
62 Function Manual, 09/2020, FW V4.7 SP13, A5E34257659B AG