Siemens SINAMICS G120 - Page 80

De󹪝ne analog signals for controlling
Procedure

1. Change the signal source for the velocity override, if required.
The velocity override refers to the velocity values you have set in the screen for programming
the traversing blocks.
You have now de󹪝ned the analog signals for controlling the traversing blocks.
❒
De󹪝ne an external signal for block change
Requirement
You have selected the "External block change" button.
Commissioning
6.8 Traversing blocks
Basic positioner
78 Function Manual, 09/2020, FW V4.7 SP13, A5E34257659B AG