Siemens SINAMICS G120 - Page 727

Index
C-727
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 01/2011
Function diagrams CANopen
Control word, CANopen, 2-547
Receive telegram, free PDO mapping
(p8744 = 2), 2-543
Receive telegram, Predefined Connection
Set (p8744 = 1), 2-544
Send telegram, free PDO mapping
(p8744 = 2), 2-545
Send telegram, Predefined Connection
Set (p8744 = 1), 2-546
Status word, CANopen, 2-548
Function diagrams Data sets
Command Data Sets (CDS), 2-651
Drive Data Sets (DDS), 2-652
Function diagrams Faults and warnings
Fault buffer, 2-646
Fault/warning configuration, 2-649
Fault/warning trigger word (r2129), 2-648
Warning buffer, 2-647
Function diagrams Fieldbus Interface
Configuration, addresses and diagnostics,
2-522
Receive telegram, free interconnection via
BICO, 2-525
Send telegram, free interconnection via
BICO, 2-526
Status words, free interconnection, 2-527
STW1 control word interconnection,
2-523
ZSW1 status word interconnection, 2-524
Function diagrams Free Function Blocks
ADD (adder), 2-607
AND (AND function block with 4 inputs),
2-603
AVA (absolute value generators), 2-609
BSW (binary changeover switch), 2-617
DFR (D flipflop), 2-616
DIF (differentiating element), 2-620
DIV (divider), 2-608
INT (integrator), 2-620
LIM (limiter), 2-618
LVM (limit value monitor, double-sided
with hysteresis), 2-621
MFP (pulse generator), 2-612
MUL (multiplier), 2-608
NCM (numerical comparator), 2-610
NOT (inverter), 2-606
NSW (numerical changeover switch),
2-617
OR (OR function block with 4 inputs),
2-604
PCL (pulse shortener), 2-612
PDE (switch-in delay), 2-613
PDF (switch-out delay), 2-614
PLI (scaling polyline), 2-611
PST (pulse extender), 2-615
PT1 (smoothing element), 2-619
RSR (RS flipflop), 2-616
Run-time groups / Sampling times, 2-602
SUB (subtracter), 2-607
XOR (XOR function block with 4 inputs),
2-605
Function diagrams General
Explanation of the symbols (Part 1), 2-500
Explanation of the symbols (Part 2), 2-501
Explanation of the symbols (Part 3), 2-502
Handling BICO technology, 2-503
Function diagrams Input/Output Terminals
Analog input 2 (AI2), 2-517
Analog inputs as Digital inputs
(DI11 ... DI12), 2-514
Analog inputs 0 ... 1 (AI0 ... AI1), 2-516
Analog outputs 0 ... 1 (AO0 ... AO1),
2-519
Digital inputs, electrically isolated
(DI0 ... DI5), 2-513
Digital outputs (DO0 ... DO2), 2-515
Temperature evaluation
Ni1000/PT1000 (AI3), 2-518