Siemens SINAMICS G120P CU230P-2 - Default Interface Settings

Installing
3.5 Default setting of the interfaces
CU230P-2 Control Units
16 Compact Operating Instructions, 01/2017, A5E38815802B AA
3.5
Default setting of the interfaces
Default setting 7: "Fieldbus with data set switchover"
Factory setting for inverters with PROFIBUS or PROFINET interface
DO 0: p0730, DO 1: p0731
AO 0: p0771[0], AO 1: p0771[1]
DI 0: r0722.0, …, DI 3: r0722.3
Speed setpoint (main setpoint): p1070[0] = 2050[1]
Jog 1 speed setpoint: p1058, factory setting: 150 rpm
Jog 2 speed setpoint: p1059, factory setting: -150 rpm
Designation in the BOP-2: FB cdS