Siemens SINAMICS G120P CU230P-2 - Page 21

Installing
3.5 Default setting of the interfaces
CU230P-2 Control Units
Compact Operating Instructions, 01/2017, A5E38815802B AA
21
Default setting 20: "3-wire (enable/on/reverse)"
DO 0: p0730,
DO 1: p0731
AO 0: p0771[0],
AO 1: p0771[1]
DI 0: r0722.0, …, DI 4: r0722.4 AI 0: r0755[0]
Speed setpoint (main setpoint): p1070[0] = 755[0]
Designation in the BOP-2: 3-wIrE 2
Default setting 21: "USS fieldbus"
DO 0: p0730, DO 1: p0731
AO 0: p0771[0], AO 1: p0771[1]
DI 2: r0722.2
Speed setpoint (main setpoint): p1070[0] = 2050[1]
Designation in the BOP-2: FB USS