CU230P-2 Control Units
6 Compact Operating Instructions, 01/2017, A5E38815802B AA
The delivery comprises at least the following components:
● A CU230P-2 Control Unit ready for operation with installed firmware. Options for
upgrading and downgrading the firmware can be found on the Internet:
Firmware (http://support.automation.siemens.com/WW/news/en/67364620).
The fieldbus interface of the Control Unit depends on the Article No. You can find the
designation, the article number, the hardware version (e.g. 02) and the firmware version
(e.g. 4.6) on the Control Unit rating plate
①.
CU230P-2 HVAC 6SL3243-0BB30-1HA3 USS, Modbus RTU, BACnet MS/TP,
CU230P-2 PN 6SL3243-0BB30-1FA0 PROFINET IO, EtherNet/IP
● Compact Operating Instructions in German and English
● The inverter contains open-source software (OSS). OSS comprises open source text and
satisfies special license terms.
The OSS license terms are saved in the inverter. You can transfer the OSS license terms
to a PC using a memory card where you can read them.
Transferring OSS license terms to a PC
Procedure
To transfer OSS license terms to a PC, proceed as follows:
1. Switch off the inverter power supply.
2. Insert an empty memory card into the card slot of the inverter.
Overview of the interfaces (Page 10)
3. Switch on the inverter power supply.
4. The inverter writes file "Read_OSS.ZIP" to the memory card within approximately
30 seconds.
5. Switch off the inverter power supply.
6. Withdraw the memory card from the inverter.
7. Insert the memory card into the card reader of a PC.
8. Please read the license terms.
You have transferred the OSS license terms to a PC.
To Next Page
Loading...
