Siemens SINAMICS G120P CU230P-2 - Installing; Plugging Control Unit onto Power Module

CU230P-2 Control Units
Compact Operating Instructions, 01/2017, A5E38815802B AA
7
Installing
3
3.1
Plugging the Control Unit onto the Power Module
Permissible Power Modules
You may operate the Control Unit with the following Power Modules:
•
PM230
•
PM240P-2
•
PM240-2
•
PM250
•
PM330
Installing the Control Unit - General
Each Power Module has an appropriate holder for the Control Unit and a release
mechanism.
Inserting the Control Unit
Proceed as follows to plug the Control
Unit onto a Power Module:
1.
Place the two catches of the
Control Unit in the matching
grooves of the Power Module.
2.
Press the Control Unit onto the
Power Module until you hear that it
latches.
You have now plugged the Control
Unit onto the Power Module.
Removing the Control Unit
Remove the Control Unit from the Power Module by pressing the release mechanism.
Special features for the PM330 Power Module
To insert or detach the Control Unit, you must open the left
-
hand cov
er of the Power Module.
Close the cover before you commission the inverter.