5. Press the "Start" button.
6. Wait until the inverter has been reset to the factory setting.
You have reset the inverter to factory settings.
Procedure with the BOP-2 operator panel
Proceed as follows to reset the inverter to factory settings:
1. In the "Options" menu, select the "DRVRESET" entry
2. Confirm the reset using the OK key.
3. Wait until the inverter has been reset to the factory setting.
You have reset the inverter to factory settings.
Commissioning
5.6 Restoring the factory setting
Converter with the CU230P-2 Control Units
190 Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE
To Next Page
Loading...
