Selecting the fixed speed setpoint, binary
You set 16 different fixed speed setpoints. You precisely select one of these 16 fixed speed
setpoints by combining four selection bits.
)L[HGVSHHGVHWSRLQWVHOHFWLRQELW
)L[HGVSHHGVHWSRLQWVHOHFWLRQELW
)L[HGVSHHGVHWSRLQWVHOHFWLRQELW
)L[HGVSHHGVHWSRLQWVHOHFWLRQELW
)L[HGVSHHGVHWSRLQW
)L[HGVSHHGVHWSRLQW
)L[HGVSHHGVHWSRLQWHIIHFWLYH
)L[HGVSHHGVHWSRLQW
)L[HGVSHHGVHWSRLQW
)L[HGVSHHGVHWSRLQW
U
S
S
S
S
S
S
S
S
S
Figure 6-28 Simplified function diagram when selecting the fixed speed setpoints, binary
Additional information about binary selection can be found in function diagram 3010 in the List
Manual.
Parameters to set the fixed speed setpoints
Parameter Description
p1001 Fixed speed setpoint 1 (factory setting: 0 rpm)
p1002 Fixed speed setpoint 2 (factory setting: 0 rpm)
... ...
p1015 Fixed speed setpoint 15 (factory setting: 0 rpm)
p1016 Fixed speed setpoint mode (factory setting: 1)
1: Direct
2: Binary
p1020 Fixed speed setpoint selection bit 0 (factory setting: 0)
p1021 Fixed speed setpoint selection bit 1 (factory setting: 0)
p1022 Fixed speed setpoint selection bit 2 (factory setting: 0)
p1023 Fixed speed setpoint selection bit 3 (factory setting: 0)
r1024 Fixed speed setpoint effective
r1025.0 Fixed speed setpoint status
1 signal Fixed speed setpoint is selected
Advanced commissioning
6.16 Setpoints
Converter with the CU230P-2 Control Units
264 Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE
To Next Page
Loading...
