Siemens SINAMICS G130 - Page 138

Commissioning
5.3 Procedure for commissioning via STARTER
Inverter chassis units
138 Operating Instructions, 07/2016, A5E00331449A
Configuring the drive unit
Figure 5-13 Configuring the drive unit
⇒
Under
Connection voltage
, choose the correct voltage. Under
Cooling method:
choose the
correct cooling method for your drive unit.
Note
Make a pre-selection
In this step, you make a preliminary selection of the chassis units. You do not define the lin
e
voltage yet.
⇒
A list is now displayed under
Drive unit selection:
. Choose the corresponding drive unit
according to type (article no.) (see rating plate).
⇒
Click
Continue >