Siemens SINAMICS G130 - Page 139

Commissioning
5.3 Procedure for commissioning via STARTER
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
139
Selecting options
Figure 5-14 Selecting options
⇒
From the combination box
Options selection:
select the options belonging to your drive
unit by clicking on the corresponding check box.
NOTICE
Damage to the sine-wave filter if it is not activated during commissioning
The sine-wave filter may be damaged if it is not activated during commissioning.
• Activate the sine-wave filter during commissioning by activating the appropriate
checkbox (option SIN).