Siemens SINAMICS G130 - Page 144

Commissioning
5.3 Procedure for commissioning via STARTER
Inverter chassis units
144 Operating Instructions, 07/2016, A5E00331449A
Selecting a standard motor type from a list
Figure 5-17 Configuring a motor – selecting the motor type, selecting a standard motor from a list
⇒
Under
Motor name:
enter a name for the motor.
⇒
Select
a standard motor from the list
⇒
From the selection box next to
Motor type:
, select the corresponding motor type
⇒
From the list
Select motor:
, select the corresponding motor
⇒
Under
Parallel connection motor
, enter the number of motors connected in parallel when
required.
Motors connected in parallel must be of the same type and rating.
⇒
Click
Continue >