Siemens SINAMICS G130 - Page 146

Commissioning
5.3 Procedure for commissioning via STARTER
Inverter chassis units
146 Operating Instructions, 07/2016, A5E00331449A
Selecting the motor type by entering the motor data
Figure 5-19 Configuring the motor – Selecting the motor type
⇒
Under
Motor name:
enter a name for the motor.
⇒
select
Enter motor data
⇒
From the selection box next to
Motor type:
, select the appropriate motor for your
application.
⇒
Under
Parallel connection motor
, enter the number of motors connected in parallel when
required.
Motors connected in parallel must be of the same type and rating.
Note
Selecting the motor type
The selection of the motor type is used to pre
-assign specific motor parameters and to
optimize the operating characteristics and behavior. De
tails are described in the list manual
in the p0300 parameter.