Siemens SINAMICS G130 - Command Sources

Operation
6.4 Command sources
Inverter chassis units
204 Operating Instructions, 07/2016, A5E00331449A
6.4
Command sources
6.4.1
"PROFIdrive" default setting
Preconditions
● The Power Module and the Control Unit have been correctly installed.
● The "PROFIdrive" default setting was chosen during commissioning:
•
STARTER (p0700):
"PROFIdrive"
•
AOP30 (p0700):
"1: G130 PROFIdrive"
Command sources
Figure 6-9 Command sources – AOP30 <--> PROFIdrive
Priority
The command source priorities are shown in the diagram "Command sources - AOP30 <->
PROFIdrive".
Note
LOCAL master control
All of the supplementary setpoints are de
activated for LOCAL master control.